SwissStop Disc 28 EXOTherm2 - Shimano XTR /XT / SLX

SwissStop Disc 28 EXOTherm2 - Shimano XTR /XT / SLX 

A direct replacement for the following Shimano brake pads:

• G05A
• G03A
• G02A
• G03S
• J03A
• J05A
• J02A
• J04C

SwissStop EXOtherm 2 pads combine an extremely durable, smooth modulating pad compound with a cooling fin equipped back plate which provides consistent, powerful braking in all conditions.

• Reduced pad wear rate is much lower than competitors
• Smooth, consistent brake performance
• Lightweight construction
• High quality springs are supplied with every set of Swissstop disc brake pads
• Supplied as pairs (for one wheel)

These pads fit the following Shimano Brake Callipers:

• XTR BR-M9000,BR-M9020,BR-M987,BR-M988,BR-M985
• XT BR-M8100,BR-M8000,BR-M785
• SLX BR-M7100,BR-M675,BR-M666
• DEORE BR-M615
• ALFINE BR-S700
• BR-RS785
• BR-R785

These pads also fit the following FSA brake callipers:

• K-Force DB-TX-9000
• Afterburner DB-TX-9150

Performance Characteristics (out of 10 - 10 is best 1 is worst)

• Initial bite: 7
• Modulation: 9
• Longevity: 10
• Heat Tolerance: 10
• Noise when dry: 9 
• Noise when wet: 7

Bedding in

Note: These pads should be "conditioned" after installation and before riding - instructions are in the pack

Step 1. On a gradual downhill slope, drag each brake for 20-30 seconds, alternating between front and rear. Repeat 2-3 times.

Step 2. On a steeper slope, engage and drag the brakes for 10-15 seconds then increase lever pressure until the bike slows almost to a complete stop. Repeat 2-3 times.

Pro Tip: The front pads will have been heated more than the rear. To achieve optimal performance, exchange the front and rear pads then repeat Step 2.

CAUTION before replacing or exchanging brake pads it is essential to let all parts cool.