Brompton G Line rear wheel - standard

Brompton G Line rear wheel - standard

This is the rear wheel for the G line, compatible with the 8 speed Alfine hub 

This wheel is not compatible with the G line electric, A, C, P or T line Brompton bicycles 

• The box contains the following: 
• The 8 speed rear wheel and Alfine hub
• 20 tooth sprocket 
• Wheel fixings and tab washers

Key features: 

• 32 spokes
• 6mm presta valve hole 
• Taped ready for tubeless use 
• Double butted spokes 
• Double walled rim with clincher 
• All black, spokes, hub and rim 
• Weight approx 2.2kg without the sprocket or fixings 
• Rim Internal rim 22.6mm
• Rim external 28mm
• For center lock disc rotor 

Also not compatible with the A, C, P or T line Brompton 

Tools required to remove and refit the wheel 

• 2mm Allen (hex) key
• 15mm Spanner 
• Torque wrench 

To remove the rear wheel:

• Ensure the bike is in the highest gear, 8
• Push the tab washer clockwise to disengage the gear cable, then pull the gear cable to disconnect it from the cable slip 
• Undo the chain catcher arm using a 2mm Allen key, pull it upwards 
• Remove the chain from the chain ring to give some slack 
• Undo the wheel nuts using a 15mm spanner 
• Remove the tab washers and the bolts from the axle - keep them safe 
• Remove the wheel from the dropouts and take the chain off the sprocket 
• Do Not squeeze the brake lever while the wheel is out, as tis will cause the brake pads to touch 

Fitting the rear wheel:

• Rotate the assembly until the cable bracket is parallel with the drive side chain stay 
• Loop the chain around the sprocket 
• insert the wheel fully in the drop outs 
• Make sure the disc rotor is in teh brake pads 
• Insert the tape washers with the white one on the non-drive side 
• Using the 15mm spanner tighten the drive side first 
• Then using the torque wrench tighten both side to 30Nm 
• Refit the chain n the chain ring and then re-install the chain catcher 
• Push the gear cable into the cable clip then rotate the assembly clip 
• Push the flat slide of the cable nut in the slot 
• There should be no reason to index the gears, just check they are working properly 

Brompton Q code:Q103647