Viewed products

Top sellers

Brompton brake caliper with Swiss Stop pads - black - for Brompton Electric

QE-BRCAL

Brompton

Brompton brake caliper with Swiss Stop pads - black - for Brompton Electric

More details

We have 17 in stock

£25.00

Data sheet

Handlebar Type:All
Colour:Black
WheelbaseLong and Short
Front / RearRear

More info

Brompton Electric brake caliper - black

Fits front or rear
Colour: Black

Consists of assembled brake caliper, with Swiss Stop brake pads/holders

This document from Park Tool could be helpful if you are trying to set-up your brakes

Fits both front and rear

Tools required: 10mm spanner

Brompton (pre-Electric)brakes history:

  • Electric - with Swiss Stop pads
  • MK4 - New 2018 model caliper - front and rear are now the same 
  • MK3 - BLACK edition - this one - originally available on BLACK edition Brompton bicycles only and released to the aftermarket in 2016
  • MK3 - is the dual pivot Brompton caliper in an anodized finish introduced in 2008/2009 
  • The MK3 was originally in silver and introduced in 2000/2001 but didn't become standard equipment until 2006
  • MK2 was a single pivot from Alhonga
  • MK1 was a single pivot from Saccon
     

Brompton Q part code: QE-BRCAL
Brompton part number: 9019236

Note: made for Brompton by Along

Important:

When fitting the this new Brompton brake caliper you should also replace the brake cable and housing. Make sure the brake cable is marked as compatible with the 2018 brake caliper, your handlebar type (M, P, S or H) and braking orientation (standard RH front, or reverse LH front etc.). If you do not use the correct cable and housing you may have problems with the function of the brakes, or the folding function of the bike

If you are fitting this caliper to a Brompton bike/fork manufactured before the 2018 model year, you will need to enlarge the hole on the rear of the fork crown to accept the 8mm diameter barrell nut. Use an 8mm drill bit to enlarge the 6mm hole on the back of the fork crown. DO NOT DRILL THROUGH THE HOLE IN THE FRONT OF THE CROWN. Use a file to remove any sharp edges and then grease the unpainted surface in the hole. This hole should then be large enough to allow the barrel nut to pass through it. We recommend removing the fork from the bike to do this.

Reviews

Write a review

Brompton brake caliper with Swiss Stop pads - black - for Brompton Electric

Brompton brake caliper with Swiss Stop pads - black - for Brompton Electric

Brompton brake caliper with Swiss Stop pads - black - for Brompton Electric

Have a question?

If your question has not yet been answered here, use the form below to ask something

(optional)
*(Required - so we can email an answer - we wont show it)

Related items / accessories